The Touch Keypad example application uses a 2.5” touch screen display to implement a keypad that you can use to control lighting based on the LED Controller example application. You can also use the keypad to display temperature, humidity, and light level values reported by an Environment Sensor example application. Once launched, the Keypad applicaition will attempt to automatically connect to Environment Sensor devices using the ISI protocol if enabled.
There are four scene buttons as well as a power button. The four scene buttons can be set to a variety of scenes depending on how the keypad is configured. The power button is used for turning the LEDs on and off.
Along with the previously mentioned buttons, there are also two addition sets of buttons used for incrementing and decrementing the hue and brightness of a particular scene.
When the keypad is "winked", which can be done from the device viewer webpage, it flashes an icon in the bottom left hand side of the keypad. This icon will flash for a full minute or until pressed.
There is also a gear button in the lower right hand side of the initial screen. Pressing this button will display the settings page. From the settings page, you can manually connect or disconnect the LED controller and environment sensor. It also allows you to send a service pin message.
Scenes, state, and color can also be input from the device viewer on the Web page.